Article ID: 264822 - View products that this article applies to.
This article was previously published under Q264822
IMPORTANT: This article contains information about modifying the registry. Before you modify the registry, make sure to back it up and make sure that you understand how to restore the registry if a problem occurs. For information about how to back up, restore, and edit the registry, click the following article number to view the article in the Microsoft Knowledge Base:
(http://support.microsoft.com/kb/256986/EN-US/ )Description of the Microsoft Windows Registry
The File Replication Service (FRS) for Microsoft Windows 2000 uses a "staging area" for replication. The default size of the staging area for FRS is approximately 660 megabytes (MB). If you want to replicate data that exceeds this amount, you may need to configure the FRS staging area to accommodate additional drive space. In addition, the volume that contains the staging area must also have this same amount of additional drive space available.
NOTE: If you have DFS running on a domain controller, the staging area size that you specify is for both SYSVOL and DFS; even if the staging areas are separated, the combined size equals the value in the registry.
WARNING: If you use Registry Editor incorrectly, you may cause serious problems that may require you to reinstall your operating system. Microsoft cannot guarantee that you can solve problems that result from using Registry Editor incorrectly. Use Registry Editor at your own risk.
When the space consumed by staging files reaches 660 MB, inbound and outbound replication is suspended until free staging space is available. Typically, when the server replicates large amounts of data, staging areas can reach their limit because the FRS moves data to the local staging area at a rate faster than the data can be transferred across the network to the staging area of the other FRS replica partner.
A display of the event that may be registered in the event log is as follows:
Event Type: WarningTo increase the size of the staging area, change the following registry setting to reflect the amount of space that is needed (enter it in kilobytes). For example, if you need to replicate 1.2 gigabytes (GB) of data, increase the staging areas of the inbound and outbound partners to 1.5 GB to ensure that the staging areas can accommodate all data to be replicated.
Event Source: NtFrs
Event Category: None
Event ID: 13522
The File Replication Service paused because the staging area is full. Replication will resume if staging space becomes available or if the staging space limit is increased.
HKLM\SYSTEM\CurrentControlSet\Services\Ntfrs\Parameters\Staging Space Limit in KBFor additional information about FRS registry entries, click the article number below to view the article in the Microsoft Knowledge Base:
Data type: REG_DWORD
Range: 0x0 - 0xFFFFFFFF KB
Default value: Default= 0xA5000 (660000 KB = 660 MB)
For example, 1.5 GB = 16e360 (1500000 KB = 1.5 GB)
221111For more information about the registry, refer to the Regentry.chm file which is installed with the Microsoft Windows 2000 Server Resource Kit.
(http://support.microsoft.com/kb/221111/EN-US/ )Description of FRS Entries in the Registry