Article ID: 246868 - View products that this article applies to.
NoticeThis article applies to Windows 2000. Support for Windows 2000 ends on July 13, 2010. The Windows 2000 End-of-Support Solution Center
(http://support.microsoft.com/win2000)is a starting point for planning your migration strategy from Windows 2000. For more information see the Microsoft Support Lifecycle Policy
Windows 2000 offers an alternative to LPR ports when you want to print to network print devices over TCP/IP. The new port monitor is called Standard Port Monitor (SPM). SPM is installed by default when TCP/IP is installed in Windows.
SPM is more robust because it uses Simple Network Management Protocol (SNMP) to read the configuration of the target print device and determine its status. If SPM cannot configure the target print device using the SPM default TCP ports and SNMP, it uses the LPR protocol if it is supported by the target device (however, it is still installed as an SPM port).
Unlike LPR, SPM uses port 9100 by default for the destination port, and randomly selects any open source port greater than 1023 as the source port.
To install an SPM port:
179156Most Hewlett-Packard Jet Direct print servers work with SPM using the new port 9100 protocol. Please check with the manufacturer of your print server to see if this configuration is supported for the respective print device.
(http://support.microsoft.com/kb/179156/EN-US/ )Updated TCP/IP Printing Options for Windows NT 4.0 SP3 and Later
The third-party products that are discussed in this article are manufactured by companies that are independent of Microsoft. Microsoft makes no warranty, implied or otherwise, regarding the performance or reliability of these products.
For additional information, see the following Microsoft WebCast: