You configure a Microsoft Windows XP-based computer for Automatic Updates, and the Windows operating system runs an automatic update. Then, you may receive an error message in the svchost.exe - Application Error
dialog box that resembles the following:
The instruction at "0x745f2780" reference memory at "0x00000000". The memory could not be 'read'.
You may also see an entry that is related to the error message in the Application log. The entry resembles the following:
Event ID: 1000
Faulting application svchost.exe, version 5.1.2600.2180, faulting
module msi.dll, version 3.1.4000.2435, fault address 0x00012780.
Additionally, if you close the error message dialog box, you may be unable to run any programs on the computer. If you leave the error message dialog box open, you can continue to use the computer. But when you try to shut down the computer, the computer stops responding.
This issue may occur because of a problem with the Automatic Updates service.
To resolve this problem, apply the hotfix that is described in the following Microsoft Knowledge Base article:
You receive an access violation when you try to install an update from Windows Update after you apply hotfix package 916089
To work around this problem, use one of the follow methods:
Leave the svchost.exe - Application Error
dialog box open, and then follow these steps.
Step1: Check whether settings for the Automatic Updates service and for the Background Intelligent Transfer Service (BITS)
To do this, follow these steps:
- Click Start, point to Run, type services.msc, and then click OK.
- In the details pane, locate and double-click Automatic Updates.
- Click the Log On tab.
- Make sure that the Local System account option is selected and that the Allow service to interact with desktop check box is cleared.
- Make sure that this service has been enabled in the Hardware Profile list. If this service has not been enabled, click Enable to enable the service.
- Click the General tab, and make sure that the Automatic option is selected in the Startup Type list. Under Service status, click Start to start the service if it is not already running.
- Repeat steps 2 through 6 for Background Intelligent Transfer Service (BITS).
Step 2: Reregister Windows Update components
To do this, follow these steps:
- Click Start, click Run,
type REGSVR32 WUAPI.DLL, and then press ENTER.
- When you receive the "DllRegisterServer in WUAPI.DLL succeeded" message, click OK.
- Type the following commands in the Open box, one after the other, and then press ENTER after each command:
Step 3: Rename the Windows Update temporary folder
The temporary folder of Windows Update may be corrupted. In this case, you can rename the temporary folder of Windows Update. To do this, follow these steps:
- Click Start, click Run, type cmd, and then press ENTER.
- At the command prompt, type
net stop Wuauserv, and then press ENTER.
- Click Start, click Run, type %windir%, and then press ENTER.
- In the folder that opens, locate and rename the SoftwareDistribution folder to SDold.
- At the command prompt, type net start Wuauserv, and then press ENTER to start the Automatic Updates service.
Follow these steps:
- Click Start, right-click My Computer, and then click Properties.
- In the System Properties dialog box, click the Automatic Updates
- Click Turn off Automatic Updates, and then click OK.
- Restart the computer.
- Use the Windows Update Web site to install updates manually.
- After you install the updates manually, turn on Automatic Updates.
Article ID: 927385 - Last Review: September 27, 2011 - Revision: 2.0
|kbwinupdwebsite kbwindowsupdatev6 kbexpertiseinter kbtshoot KB927385|